Ethernet Relay

Ethernet Relay Control

Ethernet Relay    

All The Features You Need...

  • Onboard Ethernet Interface Module
      - Plugs Directly into Router
  • Network Communication Options:
     - Virtual COM Port over Ethernet
     - Direct TCP/IP Communications
     - Supports DHCP
  • Supports Fixed IP Address
  • Base Station Software gets you up and running fast
  • Highly reliable with industry leading command set
  • ProXR Lite Versions - Not Expandable
  • ProXR Versions Expandable up to 256 Relays
  • 16 Available Timers
Ethernet Relay
Ethernet Relay Controller Board

Ethernet Relays are equipped with ProXR firmware built into the board that will allow you to Control one relay at a time, a bank of relays or all relays at once with manual and automatic refreshing command set.  The Ethernet Relay board connects to the Ethernet port of your local network hub, allowing computer controlled switching from anywhere.  The Ethernet interface mounts as a COM Port on your PC through your LAN and supports Telnet and Data Encryption with password protection

Ethernet Relay Options
Ethernet Relays are available with SPDT 5, 10 and 20 amp, SPST 30 amp and DPDT 1, 3 & 5 amp relays installed.

Ethernet Relay features an onboard Ethernet port that will connect directly to a router with a standard CAT-5 cable and supports Virtual COM Port Ethernet Communications, Direct TCP/IP communications

Also Available:

Selecting The Ethernet Interface

USB Relay ZUSB ModuleBy selecting the Ethernet interface you will be sending commands through your local area network or internet to the board.  Boards on this page are equipped with a ZETH-ME communications module that adds Ethernet communications to the board.  The board will plug directly into your router where it is assigned an IP address.  Once the IP address has been assigned the Digi Connect ME firmware will give you powerful communication options.

Selecting an Ethernet Relay Board

Below you will find all the Ethernet Relay that are available.  The difference being the amperage of the relays installed and the type of relay.  Choose the controller that fits the amperage you are switching.  You will find SPDT relays in the 5, 10 and 20 amp versions and an SPST version in 30 amp.  DPDT versions are also available with 1, 3 or 5 amp relays installed.  For more information on selecting the correct relay for your application see Choosing a Proper Amperage.

Selecting an Ethernet Relay Series

Ethernet Relay boards are available in the ProXR Lite and ProXR versions. Both versions have the same firmware installed and accept the same ProXR command set, the industry leading command set for controlling relays.  The ProXR Lite version is non-expandable, the ProXR version is expandable to 256 relays.  When you find your controller click on the Full Description link to view full specs, watch setup videos, download software and purchase.