Wireless Relays are available in 802.15.4, Bluetooth, 900 MHz and Wi-Fi with SPDT 5, 10 and 20 amp, SPST 30 amp and DPDT 1, 3 & 5 amp relays installed.
Selecting a Wireless Relay
Wireless Relays are available in five different wireless protocols - more than any other manufacturer. Each protocol is slightly different in terms of the wireless range that they can transmit in addition to the type of wireless it is. Some wireless options have different ranges that they can transmit, this is done by adding an external antenna at checkout. Select a wireless relay that fits your needs or range that you are looking to transmit.
Wireless transmission is achieved by modules installed on the board. All boards have modules installed and when you select a wireless protocol the appropriate module will be installed. Pictures shown on the site will have the short range antenna but in most cases there are external antennas available.its your needs. This will lead you to a page where you can select how many relays you would like installed on the board.
Other Wireless Relay Options
A quick note regarding some of the boards you will find below. The Contact Closure Relays do not need a computer and will transmit wirelessly between two boards with a contact closure triggering the relay and not a computer. The Key Fob Relays are triggered with a key fob wirelessly and again does not need a computer except for configuration. Scroll down for a full list of all Wireless Relays that we offer and click the links for more information on each one.
Wireless Relays are equipped with firmware built into the board that will allow you to Control one relay at a time, a bank of relays or all relays at once with manual and automatic refreshing command set. Wireless Relay Controllers allow wireless computer controlled switching and mount as a COM port on your computer. We also offer wireless contact closure switching and wireless key fob switching for applications where a computer is not used.
MirC controllers allow contact closure inputs to control relays in a remote location using a two board design. The sender board is equipped with contact closure inputs, used to control relays on the receiver board. Both sender and receiver boards are included when you purchase a MirC pair.
Push Notification boards allow you to connect a contact closure to the board and send an email or text message when the circuit is closed. The board will communicate the contact closure information to your computer over your Wi-Fi Network. N-Button Software will then send a text or email from the computer to your selected recipients.