USB Interface Module for ZigBee and XSC Devices - Top Entry
ZUSB Modules at a Glance
- Adds USB Communications to NCD Devices
- Powered from the USB Port
- Compatible with all NCD Devices with modular communications profile
- Available with Top, Side, or Top-Side Mini USB Port
- Configure the USB access of your board for your installation requirements
- Use a ZUSB Module for USB Configuration of Reactor, Key Fob or Taralist Relays
Top Configuration For USB Cable Access From Top
Transmission Lights Let You Know Communications are Active
NCD Exclusive USB Connectivity for More Reliable Communication
Modular USB CommunicationsThe ZUSB communications module adds USB communications to all NCD devices equipped to accept modular wireless communication modules. The ZUSB is powered from the USB port of your computer and includes a 6' USB Cable. The ZUSB is available in three varieties:
The ZUSB has a USB port that accepts a USB cable that enters from the side of the ZUSB module.
The ZUSB-TOP has a USB port that accepts a USB cable that enters from the top of the ZUSB module.
The ZUSB-TS has two USB ports that accepts a USB cable from the Top or the Side of the ZUSB module. Only one port can be used at a time.
The ZUSB is ONLY compatible with NCD devices and should not be used with devices manufactured by other companies.
- Benefits of USB Interface Module
- Convert any ZigBee or XSC Board to USB
- Use Only for NCD Devices
- Top or Side Entry Versions
- USB Cable Included
- 1 Channel USB Relay Now Available
- SignalSwitch Compatible
Summary of USB Communications
- USB Interface mounts as a Virtual COM Port on your PC for easy programming and 100% compatibility across ALL operating systems
- Plug in, open the Virtual COM Port at 115.2K baud, and start sending commands
- Expandable to control up to 256 Relays using the XR Expansion Port
- Available in Reactor and Key Fob, ProXR Lite and Taralist Series
- Control one relay at a time or all relays at once with manual and automatic refreshing command set
- SignalSwitch Compatible
ZUSB Modules make it easier than ever to add computer controlled switching to your most demanding computer control applications. Simply connect to your computer to a controller with this module and it will mount as a Virtual COM Port on your PC, allowing easy programming from any language that supports serial communications.
The ZUSB Series Modules can also be use to to replace a wireless module on the Reactor or Key Fob or Taralist series controllers during configuration or troubleshooting. Replacing the wireless module allows local configuration and initial setup of the controllers without using the wireless module.