
Contact Closure Over IP at a Glance...
- Sender Board Controls the Receiver Board
- Sold in Pairs
- 1 Contact Closure Input on Sender Board
- 1 Relay on Receiver Board
- When Circuit is Closed - Reley is On - Ethernet Option
- Plugs Directly Into Router
- Local Area Network Control
- Static IP Address Required - Sender Board Displays Status of Remote Relays
Selecting the Proper Amperage
For more information on selecting a board with the correct relay amperage for your application see Choosing a Proper Amperage.
New Contact Closure Over IP
The new versions are network based only and will not have the ability to communicate over the internet. A new user interface will allow manual input of the IP address in each board for them to communicate. This will be a bit more work but for users with boards on different sub networks they will have the ability to operate without the need for internet access.Contact Closure Over IP
MirC MCNET Contact Closure Over IP boards allow the contact closure input to control a relay in a remote location using a two board design. The sender board is equipped with one contact closure (no voltage) input, used to control the relay on the receiver board. Both sender and receiver boards are included when you purchase a MirC pair.Contact Closure Input & Output
The relay on the receiver board can be used to interrupt the power of a device you are switching and also as a dry contact closure output. Applications where you need to extend the range of a contact closure over a distance the MirC will work. Connect the Contact Closure output of your device to the Sender Board then wire the relay on the Receiver Board as your contact closure input in a remote location on your network.Selecting Contact Closure Over IP
