Contact Closure Over IP at a Glance...

  • Sender Board Controls the Receiver Board
      - Sold in Pairs
      - 8 Contact Closure Inputs on Sender Board
      - 8 Relays on Receiver Board
  • Ethernet Option
      - Plugs Directly Into Router
      - LAN or Internet Control
      - No Static IP Address Required
  • Sender Displays Status of Remote Relays
  • No Programming, No Configuration, No Computers

Selecting the Proper Amperage

For more information on selecting a board with the correct relay amperage for your application see Choosing a Proper Amperage.

Contact Closure Over IP

MirC MCNET Contact Closure Over IP boards allow contact closure inputs to control relays in a remote location using a two board design. The sender board is equipped with contact closure inputs, used to control relays on the receiver board.  Both sender and receiver boards are included when you purchase a MirC pair.

Contact Closure Input & Output

The relays on the receiver board can be used to interrupt the power of a device you are switching and also as a dry contact closure output.  Applications where you need to extend the range of a contact closure over a distance the MirC will work.  Connect the Contact Closure output of your device to the Sender Board then wire the relays on the Receiver Board as your contact closure input in a remote location either on your LAN over the Internet.

Selecting The Ethernet Interface

Contact Closure Over IPBy selecting the Ethernet interface you will be communicating through your local area network or internet to the board.  Boards on this page are equipped with a Lantronix XPort Pro communications module that adds Ethernet communications to the board.  The board will plug directly into your router where they will find each other on the network or over the internet!

Selecting a Contact Closure Over IP Relay

What amperage relay do you need?  MirC boards boards below have eight inputs on the sender board and eight relays installed on the receiver board.  You now have your choice of 5, 10, 20 or 30 amp relays installed.  Select the board with the amperage that you will require for more information and to purchase.  The 5-amp relay is the smallest we offer and can be used as a dry contact if needed.  For more information on selecting the correct relay for your application see Choosing a Proper Amperage.