The UAD1216 is an 8-Bit/12-Bit 16-Channel Analog to Digital Converter Expansion Module designed to attach to any board with a UXP expansion
port. That's right, turn your existing controller into an analog to digital converter!
Add 16 Channels of 8/12-Bit Analog to Digital Conversion (ADC)
0-5VDC Input Voltage Range
Common Ground for all Analog Inputs
Compatible with Fusion and ProXR UXP Series Controllers
Chain Together up to 48 Analog Input Channels
Expands in a Daisy Chain Configuration with Supplied Cables
This device is an expansion module only and cannot be used alone
Analog to Digital Converter Expansion Module
The UAD1216 is an 8-Bit/12-Bit 16-Channel Analog to Digital Converter Expansion Module designed to attach to any Fusion or ProXR UXP series
controllers. On-board Connectors shown above are used to connect a ground and an analog signal source from 0-5VDC. Black connectors on
each end are used to chain multiple UAD1216 Expansion modules to a single UXP port.
12-Bit A/D converter
This design consists of a high-quality Dual Channel 12-Bit A/D converter connected to a dual 8-channel multiplexer. To use this device, simply
use Base Station software, your Ultra controller will then communicate to this expansion module and respond with 8-Bit/12-Bit data. Ultra series
controllers are capable of reading a single channel at a time or all 16 channels at once.
48 Total Inputs per UXP Port
Up to three UAD1216 expansion boards can connect to a single UXP port. Fusion series controllers have two UXP Ports, allowing you to
monitor up to 96 Analog Inputs. ProXR UXP series controllers include a single UXP port. This expansion includes a 6″ ribbon cable.
Power is supplied by the UXP Series Controller.
Data Sheets & Quick Start Guides
Below are the Data Sheets Quick Start Guides for this board. These are the guides that will help you communicate and
configure this board.