Wired Relay at a Glance...
- Computer Controlled Wireless Relay
- Industry Leading Command Set
- Send Specific Commands to Trigger Relays
- Trigger Any or All Relays
- Program in Almost any Language
- Read 0 to 5 Volt Sensors - Contact Closure Control
- Sold in Pairs or Groups
- Dry Contact Controls Relays Wirelessly
- Wireless Communication up to 2-Miles
- No Programming, No Configuration, No Computers - Push Notification
- Send Text or Email from Dry Contact
Selecting a Wired Relay
Wired Relays are available in RS-232 and USB interfaces. Connecting to a computer or third party device is simple and allows you to send numerical commands to the board to control the relays. The boards use the ProXR Command Set which is the industry leading command set for controlling relays.
Wired Relay Modules
Communication is achieved through modules installed on the board. All boards have modules installed and when you select a wireds protocol the appropriate module will be installed.Other Wired Relay Options
A quick note regarding some of the boards you will find below. The Contact Closure Relays do not need a computer and will transmit by wiring the boards together and using a dry contact to control the relay and not a computer. Scroll down for a full list of all Wired Relays that we offer and click the links for more information on each one.
Our Wired Relays use either a RS-232 or USB cable to connect to your computer or device. The boards operate by sending specific numerical commands to the board to control the relays. Select the interface of your choice below where you will be taken to a page where you can select how many relays you would like installed on the board
MirC controllers allow contact closure inputs to control relays in a remote location using a two board design. The sender board is equipped with contact closure inputs, used to control relays on the receiver board. Both sender and receiver boards are included when you purchase a MirC pair.
Push Notification boards allow you to connect a contact closure to the board and send an email or text message when the circuit is closed. The board will communicate the contact closure information to your computer over your using a USB cable. N-Button Software will then send a text or email from the computer to your selected recipients.
